Thank you for choosing the Dart3. This document will guide you through the wiring information.

• The Dart3 comes with a 12 wire, 650mm long harness
• 15mm is pre-stripped on the input (red), ground (black), and the ignition (white) wires.
• Wire gauge is 0.35mm² 

Harness Diagram:

Wire Definition:

Driver ID:

Driver ID 1 and Driver ID 2 are used for various functions depending on configuration. Either:

• Driver ID 1 and 2 can be used to connect a Digital Matter RFID reader (https://tracklogix.com.au/shop/digital-matter-rfid-driver-id-reader/) (plugs in via the 4 way molex connector)
• Driver ID 1 can be used as the iButton Data Line, and Driver ID 2 can be used as a 3rd Digital Input. This can be independently or simultaneously.
• Driver ID 1 and 2 can be used to connect Wiegand Driver ID readers

Molex Connector:

PIN 3,4,9 and 10 goes to the 4 way Molex connector.

The four way Molex connector comes as part of the 12 way harness, with pins 3, 4, 9 and 10 from the main harness going to the connector. This can then be used for a plug and play connection to the DM RFID reader.