Thank you for choosing the Dart3. This document will guide you through the installation process, ensuring a smooth and efficient setup.

The Dart3 is supplied with a 12-wire harness. The harness contains pins for various I/Os. For many installs, where we simply are looking for 'standard' vehicle tracking, we only need to connect 3-wires. 

Wiring Description:

    Wiring Instructions:

• Connect Red (Pin 1) on the Dart3 harness to the vehicle battery (8-36V).
• Connect Black (Pin 3 - or any black wire on the harness) to chassis ground
• Connect White (Pin 8) - to an ignition source. 

    Notes:

• The White ignition input will register as 'on' when > 2.2V is applied to this line. 
• Ensure the Red wire is connected to a constant source. Sometimes it may be wired to a point which only provides power when the ignition is on. 

Testing:

Start the Vehicle and let it run for 5 minutes. Scan the QR code (or visit https://oemserver.com.au/installer) and enter the serial number of the device to check it is receiving voltage and is online correctly.

Adding vehicle Information 

The following can be completed by the Installer/Client. 

Login to the TLX Portal: https://tlx.telematics.guru

Enter the details for the device such as:

• Name
• Registration
• Odomete reading
• etc.

Were here to Help!

The Tracklogix support team is here to help. Please reach out to us if you need any assistance with the wiring or testing process.

1300 672 072

[email protected].au